CGZTD - C-147 CARPENTER'S WOOD FILLER, CAULKS, (SUPDAT)
- MSDS: CGZTD
- Manufacturer: SHERWIN WILLIAMS CO
- Product Name: C-147 CARPENTER'S WOOD FILLER, CAULKS, (SUPDAT)
- National Stock Number: 8030-00N060793
Product Identification
Product ID:C-147 CARPENTER'S WOOD FILLER, CAULKS, (SUPDAT)
MSDS Date:11/01/1995
FSC:8030
NIIN:00N060793
MSDS Number: CGZTD
Responsible Party
CLEVELAND, OH 44115
US
Emergency Phone: 216-566-2917
Info Phone: 216-566-2902
Cage: 54636
Contractor
Telephone: 800-251-2486/216-566-2242
Cage: 54636
Ingredients
SILICA, CRYSTALLINE - QUARTZ; (QUARTZ)
CAS: 14808-60-7
RTECS: VV7330000
Fraction By Weight: 15%
OSHA PEL SEE TABLE Z-3
ACGIH TLV: 0.1 MG/M3 RDUST;9495
CLAY (KAOLIN); (KAOLIN)
CAS: 1332-58-7
RTECS: GF1670500
Fraction By Weight: 10%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 2 MG/M3 TDUST; 9495
1); (CALCIUM CARBONATE)
CAS: 471-34-1
RTECS: FF9335000
Fraction By Weight: 35%
OSHA PEL 15 MG/M3 (MFR)
ACGIH TLV: 10 MG/M3 (MFR)
DRIED FILM, WEAR A DUST/MIST RESPIRATOR APPROVED BY
RTECS: 9999999ZZ
LUNG).
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE: IRRITATION OF EYES, SKIN AND
RESPIRATORY SYSTEM. IN A CONFINED AREA VAPORS IN HIGH CONCENTRATION
MAY CAUSE HEADACHE, NAUSEA OR DIZZINESS. SIGNS AND SYMPTOMS OF
OVEREXPOSURE: REDNESS AND ITCHING OR BURNING SENSATION MAY
INDICATE EYE OR EXCESSIVE SKIN EXPOSURE. CHRONIC: LONG TERM
EXPOSURE TO (EFTS OF OVEREXP)
Explanation of Carcinogenicity:SILICA, CRYSTALLINE QUARTZ: IARC
MONOGRAPHS, VOL 68, 1997: GRP 1. NTP 7TH ANNUAL RPT ON CARCIN,
1994: ANTIC (ING 5)
Effects of Overexposure:HLTH HAZ: HIGH LEVELS OF SILICA DUST, WHICH CAN
OCCUR ONLY WHERE SANDING OR ABRADING THE DRY FILM, MAY CAUSE LUNG
DAMAGE (SILICOSIS) AND POSSIBLY CANCER.
Medical Cond Aggravated by Exposure:NONE GENERALLY RECOGNIZED.
First Aid
First Aid:INHAL: REMOVE FROM EXPOSURE. RESTORE BREATHING. KEEP WARM AND
QUIET. SKIN: WASH AFFECTED AREA THOROUGHLY WITH SOAP AND WATER.
REMOVE CONTAMINATED CLOTHING AND LAUNDER BEFORE RE-USE. EYES: FLUSH
EYES W ITH LARGE AMOUNTS OF WATER FOR AT LEAST15 MINUTES. GET
MEDICAL ATTENTION. INGEST: SEEK MEDICAL ATTENTION IMMEDIATELY.
Fire Fighting
Flash Point Method:PMCC
Flash Point:>200F,>93C
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:USE NIOSH APPRVD SCBA & FULL PROT EQUIP .
WATER SPRAY MAY BE INEFT. IF H*2O IS USED, FOG NOZZLES ARE PREF.
H*2O MAY BE USED TO COOL CLSD CNTNRS (SUPDAT)
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE (DUE TO THE
BUILD-UP OF PRESSURE) WHEN EXPOSED TO EXTREME HEAT.
Accidental Release
Spill Release Procedures:VENTILATE AND REMOVE WITH INERT ABSORBENT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:KEEP CONTAINER CLOSED WHEN NOT IN USE.
TRANSFER ONLY TO APPROVED CONTAINERS WITH COMPLETE AND APPROPRIATE
LABELING. DO NOT TAKE INTERNALLY.
Other Precautions:KEEP OUT OF THE REACH OF CHILDREN. CA PROPOSITION 65:
WARNING: THESE PRODUCTS, EXCEPT FOR C-99, CONTAIN A CHEMICAL(S)
KNOWN TO THE STATE OF CA TO CAUSE CANCER.
Exposure Controls
Respiratory Protection:IF PERS EXPOS CANNOT BE CONTROLLED BELOW APPLIC
LIMS BY VENT, WEAR A PROPERLY FITTED ORG VAP/PARTICULATE RESP
APPRVD BY NIOSH FOR PROT AGAINST MATLS IN SECTION 2. WHEN
SANDING/ABRADING DRIED FILM, WEA R A DUST/MIST RESP APPRVD (SUPDAT)
Ventilation:LOC EXHST PREF. GEN EXHST ACCEPTABLE IF THE EXPOS TO MATLS
IN SECTION 2 IS MAINTAINED BELOW APPLIC EXPOS LIMS. (SUPDAT)
Protective Gloves:CHEMICAL RESISTANT GLOVES.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA .
Work Hygienic Practices:WASH HANDS AFTER USING.
Supplemental Safety and Health
MFR'S TRADE NAME/PART #:SPACKLING COMPOUNDS, FILLER & SEALANTS. FIRE
FIGHT PROC: TO PVNT PRESS BUILD-UP & POSS AUTOIGNITION/EXPLOSION
WHEN EXPOSED TO EXTREME HEAT. VENT: REFER TO OSHA STDS 1910.94, 19
10.107, 1910.108. RESP PROT:BY NIOSH FOR PROT AGAINST MATLS IN
SECTION II. WHEN SANDING/ABRADING THE DRIED (ING 4)
Chemical Properties
Boiling Pt:B.P. Text:>212F,>100C
Vapor Density:HVR/AIR
Spec Gravity:13.7
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Stability
Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:NONE KNOWN.
Hazardous Decomposition Products:BY FIRE: CARBON DIOXIDE, CARBON
MONOXIDE.
Disposal
Waste Disposal Methods:WASTE FROM THESE PRODUCT IS NOT HAZARDOUS AS
DEFINED UNDER THE RCRA 40 CFR 261. DISPOSE OF IN ACCORDANCE WITH
FEDERAL, STATE, AND LOCAL REGULATIONS REGARDING POLLUTION.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.